VALID 300-610 Exam Dumps For Certification Exam Preparation
300-610 Dumps PDF 2024 Strategy Your Preparation Efficiently
NEW QUESTION # 139
Drag and drop the SAN components from the left onto the correct design considerations on the right.
Answer:
Explanation:
NEW QUESTION # 140
Refer to the exhibit.
An engineer must assign multiple Fibre Channel IDs to a single port channel. Which two features must be enabled this goal? (Choose two.)
- A. SAN Pin Groups on the Cisco UCS Fabric Interconnects.
- B. NPIV feature on the Cisco MDS Series
- C. NPV feature on the Cisco MDS Series.
- D. end-host mode feature on the Cisco UCS Fabric Interconnects
- E. Smart Zoning feature on the Cisco UCS Fabric Interconnects
Answer: B,C
NEW QUESTION # 141
A network consultant reviews the requirements for the Storage Area Network (SAN) design. The proposed solution must offer a very efficient port usage and eliminate the need for a separate physical layer of switches and their associated ISLs. The design is not expected to require future expansion.
Which SAN topology must be used to meet these requirements?
- A. core-edge
- B. collapsed-core
- C. edge-core-edge
- D. core-distribution-access
Answer: A
NEW QUESTION # 142
Which Cisco HyperFlex feature provides virtual machine-level cost scaling for desktop virtualization growth?
- A. dedicated compute nodes
- B. encryption offload cards
- C. fabric interconnects
- D. HyperFlex Edge support
Answer: D
NEW QUESTION # 143
An engineer must interconnect customer data centers by using a 10-Gbps, unicast-only, Layer 3 circuit. The requirement is to stretch the Layer 2 connection over the tunnel, isolate STP traffic, and create more than two million logical network segments. Which solution meets these requirements?
- A. dark fiber
- B. IPsec over GRE
- C. OTV
- D. VXLAN EVPN
Answer: D
NEW QUESTION # 144
An engineer must design a Cisco UCS environment that will connection to a storage area network. The solution must include support for these conditions:
* connectivity to the existing 10 Gigabit Ethernet network
* booting the server infrastructure from the network
* integration with the existing Fibre Channel storage arrays
* lossless data transfer
Which solution should be used to meet these requirements?
- A. FCoE
- B. NFS
- C. CIFS
- D. FCP
Answer: A
NEW QUESTION # 145
Drag and drop the data center technologies from the left onto the correct descriptions on the right. Not all technologies are used.
Answer:
Explanation:
NEW QUESTION # 146
Which factor determines the choice of platform designing a Cisco HyperFlex infrastructure to support computer-aided design applications?
- A. network speed
- B. storage capacity
- C. processor count
- D. GPU support
Answer: B
Explanation:
https://www.cisco.com/c/dam/en/us/products/collateral/hyperconverged-infrastructure/hyperflex-hx-series/whitepaper-c11-740243.pdf
https://www.cisco.com/c/dam/en/us/products/collateral/hyperconverged-infrastructure/hyperflex-hx-series/hx-220c-m5-specsheet.pdf
NEW QUESTION # 147
The data center aggregation layer that uses IPv4 and IPv6 address space must act as a redundant Layer 3 gateway The solution must support a minimum of 240 virtual groups for an interface The data center aggregation layer hosts network devices from different vendors Which FHRP solution meets these requirements?
- A. HSRPv2
- B. VRRPv1
- C. VRRPV3
- D. HSRPv1
Answer: C
NEW QUESTION # 148
A company needs a solution to virtualize their legacy desktop computers. The solution must be highly resilient and able to withstand the loss of a data center site. Each compute node requires a minimum of 20 disk drives.
Which solution meets these requirements?
- A. *data center site with a strict security policy that provides access to users using a bespoke software client
*solution based on Cisco HX240 compute nodes - B. *dedicated virtual machine per hypervisors for each user in a centralized data center
*solution based on Cisco HX220 compute nodes - C. *virtual desktop infrastructure solution installed in multiple data centers that are close to the end users
*solution based on Cisco HX240 compute nodes - D. *thin client installed at each user's end station with a separate profile to retrieve sensitive data using the RDP protocol
*solution based on Cisco HX220 compute nodes
Answer: C
NEW QUESTION # 149
An engineer is implementing a storage area network where an NPV is used. The engineer notices that the servers in a storage farm are experiencing heavy traffic contention. The engineer needs to migrate traffic from heavily loaded server interfaces to interfaces with less load. When the new links are deployed, the existing traffic is not rebalanced as expected. Which feature must be used to meet these requirements?
- A. DVM
- B. multiple VSAN support
- C. NPIV
- D. disruptive load balancing
Answer: C
NEW QUESTION # 150
An engineer must deploy a Cisco HyperFlex system at two data centers. For redundancy reasons, the setup must achieve data protection in case of an entire site failure. The data must be available on both sites at all times to keep the recovery time objective to a minimum.
Which Cisco HyperFlex deployment model meets these requirements?
- A. ROBO cluster
- B. stretched cluster
- C. standard with eight nodes
- D. edge with four nodes or more
Answer: B
NEW QUESTION # 151
A company has added a new FCoE storage array to increase the performance of datastore access for end users. This storage array is directly connected to the Cisco Nexus 5672UP switches using four 10G port-channel interfaces. After deployment, the end users fail to access the datastore compared to the older solution. A network engineer verified the port-channel interface and finds that the congestion occurs when PFC frames are generated at the FCoE ingress interface. Which action must be taken to resolve the congestion issue?
- A. Enable the FCoE class in QoS on Cisco Nexus 5672UP switches.
- B. Add an additional FCoE VLAN to the SAN network.
- C. Reserve bandwidth for FCoE VLAN on the port-channel interface connected with storage.
- D. Increase the queuing buffer in the port-channel interface connected to the storage array.
Answer: A
NEW QUESTION # 152
Which mode must be enabled on a Cisco UCS Fabric Interconnect to connect directly to a storage array?
- A. NPIV mode
- B. FC switching mode
- C. FC end-host mode
- D. NPV mode
Answer: B
Explanation:
Section: Storage Network Design
Explanation/Reference: https://www.cisco.com/c/en/us/td/docs/unified_computing/ucs/ucs-manager/GUI-User-Guides/ Storage-Mgmt/3-1/b_UCSM_GUI_Storage_Management_Guide_3_1/ b_UCSM_GUI_Storage_Management_Guide_3_1_chapter_01110.html
NEW QUESTION # 153
An engineer must connect an existing Cisco UCS Fabric Interconnect to an IP-based storage array. The connection must be a port channel made directly between the fabric interconnect expansion module and the storage array. The engineer must also consider that the environment is running FCoE for storage and uses QoS to prioritize traffic.
Which port type should be used to meet these requirements?
- A. appliance
- B. server
- C. network
- D. uplink
Answer: A
Explanation:
https://www.cisco.com/c/en/us/support/docs/servers-unified-computing/ucs-5100-series-blade- server-chassis/116075-ucs-app-connectivity-tshoot-00.html
NEW QUESTION # 154
Which authentication software natively runs within the CLI of Cisco NX-OS devices?
- A. Puppet
- B. Python
- C. Ansible
- D. Chef
Answer: C
Explanation:
Section: Automation Design
NEW QUESTION # 155
Drag and drop the data center technologies from the left onto the correct descriptions on the right. Not all technologies are used.
Answer:
Explanation:
NEW QUESTION # 156
Refer to the exhibit.
The FCoE packets fail to be forwarded through the switch. What is the minimum MTU QoS requirement for the FCoE to work?
- A. 9000 bytes
- B. 2158 bytes
- C. 2000 bytes
- D. 2240 bytes
Answer: C
NEW QUESTION # 157
Refer to the exhibit. A default route must be advertised into the VXLAN fabric for internet access.
The engineer must use a static route because the edge firewall does not support any dynamic routing protocol.
Which two features must the engineer use to allow learning and withdrawing of the default route without any manual intervention? (Choose two)
- A. Network Address Translation
- B. policy-based routing
- C. IP forwarding
- D. anycast gateway
- E. HMM tracking
Answer: B,D
NEW QUESTION # 158
......
Cisco 300-610 certification exam, also known as Designing Cisco Data Center Infrastructure (DCID), is a high-level certification designed for professionals who are interested in validating their skills in designing data center infrastructure solutions. Designing Cisco Data Center Infrastructure certification covers advanced topics related to data center network design, virtualization, automation, storage, and compute solutions. 300-610 exam is designed to validate the candidate's knowledge and skills in designing complex data center infrastructure solutions using Cisco technologies.
Latest Verified & Correct 300-610 Questions: https://www.realexamfree.com/300-610-real-exam-dumps.html
100% Pass Guaranteed Download CCNP Data Center Exam PDF Q&A: https://drive.google.com/open?id=1mhDmeWaztF90WmjLjaMAHfTPr9BX9XzE
