[Oct-2021] Valid Way To Pass HP Exam Dumps with HPE6-A45 Exam Study Guide
All HPE6-A45 Dumps and Aruba Certified Switching Professional Exam Training Courses Help candidates to study and pass the Exams hassle-free!
NEW QUESTION 86
A network administrator needs to find the source of a performance issue. The administrator has seen that interfaces sometimes start to drop many packets, but the issue is intermittent, and the administrator is not sure exactly when it happens. The administrator wants to be alerted when interfaces start to drop packets. The switches already have an SNMP trap server configured on them.
What else should an administrator do on these switches?
- A. Enable debugging to the session
- B. Set the trap server to inform mode
- C. Set up RMON alarms on dropped packet statistics
- D. Enable link change SNMP traps on the switch
Answer: B
NEW QUESTION 87
Refer to the exhibit.
Switch-1 and Switch-2 connect on interface A23. The switches experience a connectivity issue. The network administrator sees that both switches show this interface as up. The administrator sees the output shown in the exhibit on Switch-1.
What is a typical issue that could cause this output?
- A. asymmetric routing introduced by a routing protocol
- B. a jumbo frame mismatch
- C. mismatched subnet mask on the VLAN for the link
- D. an issue with VLAN mismatch
Answer: A
NEW QUESTION 88
Refer to the exhibit.
A network administrator wants to prevent endpoints from spoofing the MAC address of the VLAN 2 default gateway. What should the administrator configure on Switch-1?
- A. default gateway MAC address as a port security authorized address on trk1
- B. MAC lockdown of the default gateway MAC address on trk1
- C. default gateway MAC address as a port security authorized address on ports 1-20
- D. MAC lockdown of the default gateway MAC address on ports 1-20
Answer: B
NEW QUESTION 89
Refer to the exhibit.
A company requires distribution layer switches that can provide Layer 2 and Layer 3 redundancy. The exhibit shows the proposal for these switches. Which change to the proposal will help meet the company's requirements?
- A. The proposed switches should be replaced with switches that support VSF to support the required distance between stack members.
- B. The proposed switches should be replaced with switches such as the Aruba 2930M to support the backplane stacking technology.
- C. VRRP should be implemented instead of backplane stacking to support the Layer 3 redundancy requirements.
- D. Link aggregations should be established without LACP to support the Layer 2 redundancy requirements and backplane stacking limitations.
Answer: D
NEW QUESTION 90
A network administrator applies the ACL shown in the exhibit. Which source IP address does the myList ACL deny?
- A. 10.1.0.10
- B. 10.1.1.10
- C. 10.2.1.10
- D. 10.1.2.10
Answer: C
NEW QUESTION 91
Network administrators need to configure a BGP neighbor on an AOS-Switch. What defines the neighbor as an iBGP neighbor?
- A. It has BGP synchronization enabled.
- B. Its update source is set to a private company IP address.
- C. Its remote-AS is the same as the AOS-Switch BGP AS.
- D. It has an AS number in the range of 64512 to 64535.
Answer: C
NEW QUESTION 92
An AOS-Switch enforces 802.1X it receives an Access-Accept with this HPE VSA from its RADIUS server.
The switch then rejects the client. What is one requirement for the switch to accept the message and authorizes the client?
- A. The RADUS server settings must permit dynamic authorization
- B. The initial user role must be set to the factory default permit any role.
- C. User role authorization must be enabled globally on the switch.
- D. An aaa authentication local user group must have the contractor name.
Answer: B
NEW QUESTION 93
Refer to the exhibit.
Network administrators set up PIM-DM to route multicast traffic from Server 1 to clients in VLAN 24. The multicasts are not active now, but the administrators want to determine which path the multicasts will take.
What should the administrators check to help them calculate this path?
- A. If Switch-2 or Switch-3 is listed as an RP in the Switch-1 RP set
- B. If the Switch-2 DR priority on VLAN 10 is higher than the Switch-3 DR priority on VLAN 11
- C. If Switch-2 or Switch-3 has the highest IP address on a VLAN that runs PIM-DM.
- D. What the next hop is for the unicast route that Switch-1 uses to reach 10.2.2.2
Answer: D
NEW QUESTION 94
Two AOS-Switches are directly interconnected. The network administrator wants to prevent broadcast storms and other Layer 2 issues that could occur if there is physical damage to a cable.
Which technology should the administrator implement on the connected switch interfaces?
- A. MAC Lockdown
- B. Bidirectional Forwarding Detection (BFD)
- C. Spanning Tree Root Guard
- D. Unidirectional Link Detection (UDLD)
Answer: D
NEW QUESTION 95
A company wants to implement 802.1X authentication to authenticate client devices on AOS-Switch ports.
The company has a RADIUS server that uses PEAP MSCHAP-v2 for the authentication method. What is one task administrators should complete before they implement the plan?
- A. Set up an isolated VLAN in the network for the 802.1X communications.
- B. Configure DHCP services on the AOS-Switches for pre-authenticated clients.
- C. Ensure client devices trust the RADIUS server certificate.
- D. Install personal certificates on client devices.
Answer: A
NEW QUESTION 96
What is a reason to implement port security on an AOS-Switch?
- A. to control management access to the switch CLI based on device, as well as user credentials
- B. to filter traffic at the edge, based on multiple criteria in the MAC header
- C. to enhance the security of an 802.1X solution
- D. to simplify provisioning for devices such as IP phones or printers
Answer: C
Explanation:
Reference: http://h22208.www2.hpe.com/eginfolib/networking/docs/switches/WB/15-
18/5998-
8152_wb_2920_asg/content/ch14s02.html
NEW QUESTION 97
Refer to the exhibits.
Exhibit 1
Exhibit 2
Exhibit 1 shows the topology for the network. The network administrator sees the log entries shown in Exhibit 2. Which type of failure is indicated?
- A. A link between Switch-1 and Switch-2 went down. BFD detected the lost connectivity and behaved as expected.
- B. BFD was set up incorrectly on Switch-2, so it caused Switch-2 to lose adjacency with Switch-1 rather than repair the session.
- C. Graceful restart helper was not enabled on Switvh-2, so BFD was unable to operate correctly, and the session was taken down.
- D. A hardware issue caused a unidirectional link; BFD detected the issue at Layer 2 and prevented a broadcast storm.
Answer: B
NEW QUESTION 98
Exhibit
The routing switches shown in the exhibit run OSPF on the links between each other. The commander in the Switch-1 VSF fabric goes down. Traffic is disrupted for several seconds.
What should a network administrator do to support a faster failover in a similar situation?
- A. Configure graceful restart, or nonstop OSPF, on Switch-1 and Switch-2 with a proper timer.
- B. Configure echo mode BFD on the VLAN that connects Switch-1 and Switch-2
- C. Create a redundant virtual link between Switch-1 and Switch-2.
- D. Add VRRP on the VLAN between Switch-1 and Switch-2
Answer: D
NEW QUESTION 99
Refer to the exhibits.
Exhibit 1
Exhibit 2
A network administrator needs to understand why endpoints that use Switch-3 as their default router can no longer reach some resources. The exhibit shows the OSPF link state database (LSDB) on Switch-1 when the OSPF solution was first deployed and the current LSDB.
What is a likely place to find the issue?
- A. in the Switch-1 OSPF Area 1 configuration settings
- B. in the connectivity status between Switch-1 and Switch-2
- C. in the Switch-3 OSPF Area 1 configuration settings
- D. in the connectivity status between Switch-3 and Switch-1
Answer: B
NEW QUESTION 100
What is a reason to create a virtual link between two OSPF routers?
- A. to permit an OSPF adjacency between two VSF fabrics
- B. to create a connection between two areas that are not directly connected to Area 0
- C. to monitor connectivity with the neighbor, but not exchange the routing table
- D. to permit OSPF to operate between two routers that also run VRRP
Answer: B
NEW QUESTION 101
......
Get Latest [Oct-2021] Conduct effective penetration tests using RealExamFree HPE6-A45
