Aug-2021 Latest RealExamFree HPE6-A45 Exam Dumps with PDF and Exam Engine Free Updated Today!
Following are some new HPE6-A45 Real Exam Questions!
NEW QUESTION 22
Refer to the exhibits.
Exhibit 1
Exhibit 2
Network administrators are alerted to high interface utilization on a switch by a management solution. They examine the utilization on the uplink interfaces several times an hour during problem times. The exhibit shows output typical of times of congestion. The administrators want to allocate bandwidth fairly and reduce congestion on the uplinks.
What could help meet these requirements?
- A. an outbound rate limit on interfaces 1 and 2
- B. an outbound rate limit on each edge port
- C. a per-queue rate limit on interfaces 1 and 2
- D. a broadcast rate limit on each edge port
Answer: D
NEW QUESTION 23
Refer to the exhibit.
An AOS-Switch has the ACL shown in the exhibit. A network administrator then enters these commands:
Switch(config)# mac-access-list standard myACL
Switch(config-std-macl)# deny 007d.45cc.0000 0000.0000.ffff
How does this ACL treat these frames:
1 = 007d.45cc.ffff 2 = 007d.45cc.0000
- A. It denies frame 1 and permits frame 2.
- B. It permits both frames.
- C. It denies both frames.
- D. It permits frame 1 and denies frame 2.
Answer: A
NEW QUESTION 24
A company deploys AOS-Switches at sites with inexperienced IT staff. The man office network administrators want to monitor thresholds to generate alerts on branch switches.
What should be set up for this purpose?
- A. an RMON alarm
- B. an SNMP trap
- C. an sFlow instance
- D. an auto-config server
Answer: B
NEW QUESTION 25
Refer to the exhibit.
The network administrator enables DHCP snooping globally and on VLAN 2. An additional step is mandatory for DHCP snooping to operate correctly and for clients to receive DHCP settings.
What is the additional mandatory step?
- A. Define an authorized DHCP server.
- B. Define edge ports as untrusted DHCP ports.
- C. Enable ARP protection.
- D. Define trk1 as a trusted DHCP port.
Answer: B
NEW QUESTION 26
Which benefit is provided by MD5 authentication for BGP?
- A. It protects BGP routing information from eaveasdropers.
- B. It validates that BGP message arrive from an authorized device.
- C. It enables users to authenticate to server across BGP AS boundaries.
- D. It verifies that received BGP routes have valid next hop IP addresses
Answer: D
NEW QUESTION 27
Refer to the exhibit.
An administrator created a backplane stack with the plug-and-play method and did not after the default backplane stacking settings. Later, who backplane stacking links failed as shown in the exhibit. The network administrator then restored the failed links.
When the stack is reformed, which switches become commander and standby?
- A. Member 4 remains commander, and Member 1 becomes standby
- B. Member 1 becomes commander, and Member 2 becomes standby
- C. Member 1 becomes commander, and Member 4 becomes standby
- D. Member 4 remains commander, and Member 5 remains standby
Answer: A
NEW QUESTION 28
Refer to the exhibit.
Switch-1 and Switch-2 connect on interface A23. The switches experience a connectivity issue. The network administrator sees that both switches show this interface as up. The administrator sees the output shown in the exhibit on Switch-1.
What is a typical issue that could cause this output?
- A. asymmetric routing introduced by a routing protocol
- B. a jumbo frame mismatch
- C. mismatched subnet mask on the VLAN for the link
- D. an issue with VLAN mismatch
Answer: A
NEW QUESTION 29
Refer to the exhibit.
Endpoints in VLAN 2 connect directly to this switch. These devices should only be able to send DHCP, DNS, HTTP, and HTTPS traffic. However, they are able to send any traffic. Based on the exhibit, what is the issue?
- A. The ACL lacks a deny ip any any statement at the end
- B. The ACL is applied in the wrong direction
- C. The name of the ACL applied to VLAN 2 is incorrect
- D. The switch does not have an IP address on VLAN 2
Answer: C
NEW QUESTION 30
Exhibit
Switch-2, Switch-5 and Switch-6 currently have many OSPF routes to Area 1 networks.
The network administrator wants to replace these routes with a single aggregated route to
10.10.1.0.0/16 on each switch. Where should the administrator specify the 10.1.0.0/61 range?
- A. In the Switch-2 OSPF Area 2 configuration
- B. In the Switch-2, Switch-5, and Switch-6 OSPF global configuration
- C. In the Switch-1 OSPF Area 0 configuration
- D. In the Switch-1 OSPF Area 1 configuration
Answer: C
NEW QUESTION 31
Refer to the exhibits.
Exhibit 1
Exhibit 2
A network administrator wants to set up mirroring of traffic from port 1 on Switch-1 to port 1 on Switch-2.
Exhibit-2 shows the commands that the administrator enters. The mirroring does not work correctly.
What must the administrator do to correct the error?
- A. Remove the commands, and re-enter them on Switch-1 first and then on Switch-2.
- B. Specify the mirror endpoint command on Switch-1 and the mirror 1 remote-ip command on Switch-2.
- C. Re-configure the mirror endpoint command on Switch-2 with the IP addresses reversed in order.
- D. Change the port ID on Switch 1 to 50001, so that it is unique from the port ID on Switch-2.
Answer: C
NEW QUESTION 32
Refer to the exhibits.
Exhibit 1.
Exhibit 2.
The exhibits show the current operational state for routes on Switch-3. The company wants Switch-3 to prefer the link to Switch-1 over the link to Switch-2 for all intra-area, inter-area, and external traffic.
What can the network administrator do to achieve this goal?
- A. Set the OSPF administrative distance on Switch-2 higher than 110.
- B. Set the OSPF cost on VLAN 108 higher than 1 on Switch-2 and Switch-3.
- C. Set the OSPF area type to normal on all of the switches in Area 1.
- D. Set the cost in the OSPF Area 1 stub command higher than 1 on Switch-2.
Answer: D
NEW QUESTION 33
Refer to the exhibit.
What must the network administrator do on Switch-1 to enable this switch to advertise 192.0.2.0/24 to the router at 192.168.1.1?
- A. Enable eBGP multihop to the 192.168.1.1 neighbor.
- B. Redistribute OSPF routes into the BGP process
- C. Enter a static route to 192.0.2.0/24 to the black hole.
- D. Enter the network 192.168.1.0/24 command in the BGP context.
Answer: C
NEW QUESTION 34
Refer to the exhibits.
Exhibit 1
Exhibit 2
The network administrator needs to set up BGP between the two company switches, Switch-1 and Switch-2. The BGP connection does not establish. Based on the exhibits, what does the administrator need to do to fix the issue?
- A. Enable the multihop option for the neighbor on each of the switches.
- B. Set the update source for the neighbor to the local loopback interface on each switch.
- C. Enable BGP on the interfaces that the switches use to reach each other.
- D. Enter the network command for 10.0.0.0/24 in the router BGP mode on each switch.
Answer: B
NEW QUESTION 35
Refer to the exhibit.
The access layer AOS-Switches currently run DHCP snooping on VLAN 2 and connection rate filtering on edge ports. They are at default settings for ARP protection. A network administrator then enters these commands on each of the access layer switches:
Switch(config)# arp-protect vlan 2 Switch(config)# arp-protect
Which behavior accurse?
- A. The switches can now prevent ARP poisoning attacks and do not interfere with legitimate communications.
- B. The switches can prevent ARP poisoning attacks, but legitimate communications with VLAN 2 could also be disrupted.
- C. The switches will forward legitimate traffic and prevent ARP poisoning attacks, but interfere with connection rate filtering.
- D. The switches will not apply ARP protection due to interference from DHCP snooping, so the commands have no effect on current behavior.
Answer: A
NEW QUESTION 36
Refer to the exhibits.
Exhibit 1
Exhibit 2
Switch-1 has a power issue that causes it to fail. When Switch-1 comes back up, endpoints lose connectivity for a few minutes. The network administrator decides to enter this command on Switch-1:
Switch-1 (config)# vlan 10 vrrp vrid 10 preempt-delay-time 120
Exhibit 2 shows the VRRP configuration just after the change. What is the effect of this change?
- A. Switch-1 now waits to take over as Master if it fails and recovers. This should prevent the connectivity issue from occurring again.
- B. Switch-1 experiences an internal error in the VRRP process. This error causes Switch-2 to take over as Master for VLAN 2.
- C. Switch-1 and Switch-2 both become Master in their own VRRP virtual router due to the delay timer mismatch. The mismatch must be fixed.
- D. Switch-1 continues to act as it did before the preempt delay time was set. Administrators must plan additional changes to fix the issue.
Answer: B
NEW QUESTION 37
Refer to the exhibit.
Every switch in the exhibit will route traffic. The company requires a topology in which failover for switch-to- switch links is exclusively handled by the routing protocol and occurs as quickly as possible. Which topology should the administrator use?
- A. D
- B. C
- C. A
- D. B
Answer: D
NEW QUESTION 38
The implementation plan for AOS-Switches calls for them to implement port-based tunneled node. The Aruba Mobility Controllers that will support the AOS-Switches run software 8.1. The controllers will also support APs, are managed by Mobility Master, and use clustering.
Which issue with this plan needs to be addressed?
- A. The switches must use role-based tunneled node to work with clustering controllers.
- B. The controllers must have their software updated before they can support the switches.
- C. The switches cannot connect to controllers that also support APs.
- D. The controllers cannot support tunneled node with AOS-Switches when they are managed by the Mobility Master.
Answer: A
NEW QUESTION 39
An AOS-Switch has type of service disabled on it globally. The administrator enters:
AOS-Switch(config)# interface 1 qos trust device aruba-ap
What is the effect of this command?
- A. if the AOS-Switch is integrated with an Aruba Mobility Controller, it uses QoS settings sent by the controller to prioritize traffic sent on interface 1
- B. if the AOS-Switch is integrated with an Aruba Mobility Controller, it uses QoS settings sent by the controller to classify traffic received on interface 1
- C. if interface 1 connects to an Aruba AP, it uses the incoming DSCP and a global DSCP map to prioritize traffic received on this interface
- D. if interface 1 connects to an Aruba AP, the switch marks all traffic received on the interface with a higher than default priority value
Answer: A
NEW QUESTION 40
A network administrator applies port security to a port with the send-alarm action. What does the switch do if it detects traffic from an unauthorized MAC address on the port?
- A. It disables the port, but sends no SNMP trap
- B. It blocks the traffic, but sends no SNMP trap
- C. It blocks the traffic, and it sends and SNMP trap.
- D. It forwards the traffic, and it logs an event.
Answer: C
NEW QUESTION 41
......
Resources From:
- 2021 Latest RealExamFree HPE6-A45 Exam Dumps (PDF & Exam Engine) Free Share: https://www.realexamfree.com/HPE6-A45-real-exam-dumps.html
Free Resources from RealExamFree, We Devoted to Helping You 100% Pass All Exams!
