Refer to the exhibit.

A network administrator completes the initial configuration dialog of the Mobility Controllers (MCs) and they join the Mobility Master (MM) for the first time. After the MM-MC association process, the network administrator only creates AP groups, VAPs, and roles. Next, the network administrator proceeds with the configuration of the policies and creates the policy shown in the exhibit.
Which additional steps must be done to make sure this configuration takes effecr over the contractor users?

• A. Apply the policy in the contractors user role.
  Enable deep packet inspection.
  Reload the MCs.
• B. Apply the policy in the contractors user role.
  Enable deep packet inspection.
• C. Enable firewall visibility
  Enable web-content classification
  Reload the MMs.
• D. Enable the firewall visibility.
  Enable web-content classification
  Reload the MCs.

Refer to the exhibit.

A 7008 Branch Office Controller (BOC) is deployed in a remote office behind a core router. This core router does not support 802.1q encapsulation. The Mobility Controller (MC) is the gateway for two tunneling mode SSIDs, as shown in the exhibit.
Which two different configuration options ensure that wireless users are able to reach the branch network through the router? (Select two.)

• A. Configure all ports of the BOC as access ports on the controller VLAN, and change the gateway of clients to the core router IP.
• B. Configure the uplink of the BOC as a trunk port, tagging the controller and the SSID VLANs, and enable NAT for the SSID VLANs.
• C. Configure the uplink of the BOC as a trunk port that permits the controller and the SSID VLANs. The controller VLAN must be native.
• D. Configure the uplink of the BOC as an access port on the controller VLAN, and enable NAT for the SSID VLANs.
• E. Configure the uplink of the BOC as an access port on the controller VLAN, and add static router in the router for the SSID VLAN subnets.

Refer to the exhibit.

A network administrator deploys a Mobility Master (MM)-Mobility Controller (MC) network with APs in different locations. Users in one of the locations report that the WiFi network works fine for several hours, ang then they are suddenly disconnected. The symptom may happen at any time, up to three times every day, and lasts no more than two minutes.
After some research, the network administrator logs into the MM and reviews the output shown in the exhibit.
Based on this information, the network administrator logs into the MM and reviews the output shown in the exhibit.
Based on this information, what is the most likely reason users get disconnected?

• A. Users in the 2.4 GHz band are being affected by high interference.
• B. Adpative Radio Management is reacting to RF events.
• C. AirMatch is reacting to non-scheduled RF events.
• D. AirMatch is applying a scheduled optimization solution.

Refer to the exhibit.

Airware 8.2 customer can view a wireless client that connects to the network, but cannot collect the client data information (such as healthy status) from AirWave GUI.
Which staps must be completed on the controller and AirWave in order to obtain the clients health information? (Choose three.)

• A. Enable an SNMP trap on the controller.
• B. Enable Syslog and SNMP Trap Collection on Airwave.
• C. Enable Prefer AMON vs SNMP Polling on AirWave.
• D. Enable AMON data collection on Airwave.
• E. Ensure the Controller is configured to send AMON data to the AirWave server.
• F. Ensure PAPI traffic can pass between Airwave and the controller.

Refer to the exhibit.

A network administrator is validating client connectivity and executes the show command shown in the exhibit. Which authentication method was used by the wireless station?

• A. EAP authentication
• B. 802.1X user authentication
• C. MAC authentication
• D. 802.1X machine authentication