DEA-5TT2 by EMC Actual Free Exam Questions And Answers [UPDATED 2024]
DEA-5TT2 Questions Truly Valid For Your EMC Exam!
NEW QUESTION # 23
What accurately describes the comparison between stacking and VLT?
- A. Stacked switches share a common control plane while VLT peers maintain their own control plane.
- B. Stacked switches and VLT peers allow "single pane of glass" management by maintaining a single control plane.
- C. Both VLT and stacking allow devices to use different versions of firmware provided that the switch family/ series is the same.
- D. VLT allows for more physical devices to appear as one virtual device than stacking does.
Answer: A
NEW QUESTION # 24
You recently joined a company as a junior-level network administrator. You have been tasked with designing the IPv4 scheme for five networks that will be used for training classrooms. These networks need to support no more than 28 devices each. Due to the existing network design, the senior-level network administrator has asked you to work on network 192.168.40.0/24.
If all networks must be made to logically start with the lowest numbered network and end with the largest numbered network, what is the network ID for the third network?
- A. 192.168.40.32/27
- B. 192.168.40.64/27
- C. 192.168.40.96/27
- D. 192.168.40.128/27
Answer: B
NEW QUESTION # 25
A VLAN has been configured to have an IPv6 address and a stateless address autoconfiguration for clients.
Which IPv6 address prefix will the default gateway have on a client?
- A. fd01::/64
- B. fe08::/64
- C. fe80::/64
- D. ff02::/8
Answer: C
NEW QUESTION # 26
Which port type should be used for only VLAN-unaware devices?
- A. Access port
- B. General port
- C. Trunk port
- D. Hybrid port
Answer: D
NEW QUESTION # 27
An Ethernet switch receives a frame from a directly connected host. The source MAC address of the frame is not present in the MAC address table for the switch. However, the destination address is present in the MAC address table.
What does the switch do with the frame?
- A. Flushes the destination MAC address and updates the MAC address table in the switch.
- B. Adds the source MAC address and port to the MAC address table and forwards the frame.
- C. Discards the frame on all ports and sends an error message back to the host.
- D. Floods the frame to all ports except for the port the frame originated from to locate the source MAC address.
Answer: B
NEW QUESTION # 28
On Switch A, a static route has been redistributed into OSPF. Which type of OSPF router will this process make Switch A?
- A. Backbone Router (BR)
- B. Area Border Router (ABR)
- C. Designated router (DR)
- D. Autonomous System Boundary Router (ASBR)
Answer: D
NEW QUESTION # 29
Refer to the exhibit.
Switch A and Switch B are connected to each other. Both switches use interfaces Gi1/0/1 and Gi1/0/2. Switch A has a Spanning Tree priority of 8192 and Switch B has the default priority. Which interface becomes the root port?
- A. Switch B Gi1/0/2
- B. Switch A Gi1/0/1
- C. Switch A Gi1/0/2
- D. Switch B Gi1/0/1
Answer: B
NEW QUESTION # 30
Which IPv6 scope is used for private addressing on a local network?
- A. Area wide
- B. APIPA
- C. Unique local
- D. Global
Answer: C
NEW QUESTION # 31
Which BASE-T Ethernet standard specifies a CAT6 cable type?
- A. 10GBASE-T
- B. 10BASE-T
- C. 2.5GBASE-T
- D. 5GBASE-T
Answer: A
NEW QUESTION # 32
Which criteria is used to define an extended MAC ACL filter?
- A. Ethernet frame type and frame size
- B. Destination MAC address and Ethernet frame type
- C. Source and destination MAC addresses
- D. Destination TCP port number and source MAC address
Answer: C
NEW QUESTION # 33
What accurately describes OSPF?
- A. Exterior gateway distance-vector protocol
- B. Interior gateway distance-vector protocol
- C. Interior gateway link-state protocol
- D. Interior gateway path-vector protocol
Answer: C
NEW QUESTION # 34
What accurately describes IPv6 addressing?
- A. IPv6 uses broadcast addresses for neighbor discovery.
- B. IPv6 addresses are denoted by eight groups of four hexadecimal numbers.
- C. IPv6 is used to converse IP addresses and utilize private addresses.
- D. IPv6 uses 128 hexadecimal numbers instead of the 32 hexadecimal numbers used by IPv4.
Answer: B
NEW QUESTION # 35
Which IPv4 address is in the same network as the IP address 182.15.24.40/23 and assignable to a host device?
- A. 182.15.26.10
- B. 182.15.25.0
- C. 182.15.23.224
- D. 182.15.25.255
Answer: B
NEW QUESTION # 36
How is a switch different from a hub?
- A. A switch tracks MAC addresses of all connected devices.
- B. A switch decreases the number of broadcast storms.
- C. A switch does not include any latency into the frame transfer time.
- D. A switch operates at a lower, more efficient layer of the OSI model.
Answer: A
NEW QUESTION # 37
What is the bandwidth of an RPM for a C9010 Network Director?
- A. 2.56 Tbps
- B. 2.56 Mbps
- C. 1.52 Tbps
- D. 200 Mbps
Answer: A
NEW QUESTION # 38
On which Dell EMC Networking switches can Multi-Chassis Link Aggregation (MLAG) be configured?
- A. N-Series
- B. S-Series
- C. Z-Series
- D. C9000 Series
Answer: A
NEW QUESTION # 39
Which option is used to configure Network Address Translation (NAT) to provide one-to-one mapping between local and global addresses?
- A. Inside source static
- B. Outside source static
- C. Overload
- D. PAT
Answer: A
NEW QUESTION # 40
Which component translates data, signaling, and protocols to facilitate the data flow between the end device and the network?
- A. Switch
- B. NIC
- C. Port
- D. Transceiver
Answer: D
NEW QUESTION # 41
Which fields are mandatory TLVs in a LLDP PDU frame?
- A. Chassis ID, Port ID, and Time-to-Live
- B. IP Address, Default Gateway, and DNS
- C. System Capabilities and Management Address
- D. Port Description, System Name, and System Description
Answer: A
NEW QUESTION # 42
Router A is directly connected to Router B over an Ethernet link. The local interface address for the Router A Fo0/48 interface is 144.254.32.2/24. Which routing table entry is visible on Router A?
- A. 144.254.32.2/24
- B. 144.254.0.0/24
- C. 144.254.32.0/24
- D. 144.254.0.0/16
Answer: C
NEW QUESTION # 43
Which message is sent by a router when TTL expires?
- A. Echo reply
- B. Echo request
- C. Time exceeded
- D. Destination unreachable
Answer: C
NEW QUESTION # 44
......
EMC DEA-5TT2 certification is ideal for individuals who are looking to establish themselves as experts in the field of networking. Associate - Networking Exam certification is targeted towards network administrators, network engineers, and other IT professionals who are responsible for designing, implementing, and managing network infrastructures. Associate - Networking Exam certification exam is designed to validate the skills and knowledge of individuals in the field of networking, and to ensure that they are able to effectively manage and troubleshoot complex network environments.
Get instant access of 100% real exam questions with verified answers: https://www.realexamfree.com/DEA-5TT2-real-exam-dumps.html
