Passing CWNP CWDP-304 Exam Using 2024 Practice Tests
CWDP-304 Study Guide Brilliant CWDP-304 Exam Dumps PDF
NEW QUESTION # 70
A wireless network with fewer APs at higher power levels to cover a large area is said to be which of the following?
Response:
- A. Ideal for roaming
- B. Capacity based
- C. Coverage based
- D. Destined for failure
Answer: C
NEW QUESTION # 71
A wireless engineer from your company performed a site survey in an office building where a wireless network extension was needed. He reports that while performing a Layer 1 sweep near a meeting room full of people, he detected RF activity with a very low duty cycle. He is unsure how to interpret what he recorded to determine its impact on a future Wi-Fi network.
What is true about this RF environment and its potential impact on the WLAN?
- A. The signal affects the entire spectrum and will render the wireless network unusable. It must be located and removed.
- B. The signal is typical of a high radio card background noise. It shows that the card used for the Layer 1 sweep should be replaced and the Layer 1 sweep re-
- C. The signal is alternating between peaks (high interference level) and valleys (low interference level).
The network channel design must be
built to avoid the affected peak frequencies. - D. The signal has a low duty cycle and should not be of major impact on the wireless network.
Answer: D
NEW QUESTION # 72
What functions may be performed by a WIPS?(Choose all that apply.)
- A. Data forensics and analysis
- B. Distributed protocol analysis
- C. Automated threat mitigation
- D. Performance monitoring and response
- E. Client access to the distribution system
Answer: A,B,C,D
NEW QUESTION # 73
What frequency and power did 802.11y provide?
Response:
- A. 3.7-3.75 GHz, 15W EIRP
- B. 5.65-5.7 GHz, 5W EIRP
- C. 5.25-5.35 GHz, 10W EIRP
- D. 3.65-3.7 GHz, 20W EIRP
Answer: D
NEW QUESTION # 74
What metric implements the simplest algorithm and lowest accuracy in networks requiring locations?
Response:
- A. Time Difference of Arrival (TDoA)
- B. Angle of Arrival (AoA)
- C. Received Signal Strength Indicator (RSSI)
- D. Time of Arrival (ToA)
Answer: C
NEW QUESTION # 75
Your customer requires fast secure roaming. Which two types of roaming are specified in 802.11-2016 FT roaming that will help meet this goal?
- A. FT and TKIP
- B. Over-the-Air and Over-the-Wire
- C. Over-the-Air and Over-the-DS
- D. FT and OKC
Answer: C
NEW QUESTION # 76
A bandpass filter has a maximum in-band loss of 1.5 dB, ripple of 0.4 dB, and a return loss of 15 dB. What is the minimum in-band loss?
Response:
- A. 1.5 dB
- B. 1.1 dB
- C. 13.5 dB
- D. 1.9 dB
Answer: B
NEW QUESTION # 77
An enterprise customer is subject to the highest standards for network uptime. When designing their wireless network, you should consider which of the following?(Choose all that apply) Response:
- A. The failover of the wired network only
- B. The physical aspects such as power and cabling
- C. The failover of the wireless and wired network
- D. The failover of the wireless network only
Answer: B,C
NEW QUESTION # 78
When deploying APs outdoors, what additional component needs to be used that is not needed indoors?
- A. NEMA enclosures
- B. Antennas
- C. PoE
- D. Ethernet cables
Answer: A
NEW QUESTION # 79
An associated STA detects a new BSS with the same SSID as the STA's current BSS. The new BSS uses a different IP subnet than the current BSS.
If the STA is configured to use 802.1X/EAP preauthentication, what is likely to occur?
- A. The STA will attempt to preauthenticate and succeed if IP Mobility is enabled on the AP or WLAN controller.
- B. The STA will not attempt to preauthenticate because the new BSS uses a different IP subnet.
- C. The STA will attempt to preauthenticate and succeed if DHCP is supported on the new subnet.
- D. The STA will attempt to preauthenticate, but fail because the new BSS uses a different data-link broadcast domain.
Answer: D
NEW QUESTION # 80
In the enterprise, when is WPA/WPA2-Personal generally a recommended solution?(Choose all that apply.) Response:
- A. When client devices do not support 802.1X/EAP
- B. When mobile device applications require high-latency roaming times between APs
- C. When the network security policy demands that each user have unique access credentials
- D. When client devices are provisioned in bulk and would otherwise share 802.1X credentials
Answer: A,D
NEW QUESTION # 81
An MSA commonly addresses at least which two legal categories?
- A. Intellectual property protection
- B. Hold harmless
- C. Nondisclosure agreement
- D. Indemnity clause
Answer: C
NEW QUESTION # 82
Using a SCA means that all APs will be using the same channel in a given layer. How is the AP with which the client associates determined?
- A. All APs share a virtual BSSID. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from the client.
- B. All APs share a virtual IP address. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from the client.
- C. All APs share a virtual Multicast Address. A controller will tell the closest AP to the client to communicate with it, since it has a greater RSSI from the client.
- D. The client selects the AP based on a known set of MAC to BSSID mappings stored in the clients authorized SSID listing.
Answer: B
NEW QUESTION # 83
Aesthetics are very important in some environments. What common installation technique can be used to best meet this requirement in a stadium?
- A. Using enclosures under the seats or on hand-rails
- B. Painting to match team colors
- C. Mounting on the walls
- D. Mounting on a non-fixed pole
Answer: A
NEW QUESTION # 84
You told your customer that multipath fading may be mitigated simply by moving one or both of the receivers antennas a small amount, usually by one to four wavelengths away from its original position. Your customer is prepared to make the change, but does not know the wavelength for
802.11ac.
What is the approximate wavelength of an 802.11ac radio wave?
- A. 15.24 cm (6 inches)
- B. 5.5 cm (2.16 inches)
- C. 12 cm (4.72 inches)
- D. 45 cm (17.71 inches)
Answer: B
NEW QUESTION # 85
Who should be in the final meeting from the customer-side after successfully implementing a WLAN infrastructure?
- A. The customer's customers
- B. End-users
- C. Remote workers
- D. CEO or CFO
Answer: B
NEW QUESTION # 86
Your customer's 802.11n laptops are not able to see the SSID in the 5 GHz band in the conference room.
When doing a walkthrough using one of
these laptops, you confirm that it is unable to see the SSID in the 5 GHz band in the conference room. When using your own 802.11 ac laptop, you're able to see the SSID. What is the most likely cause of this problem?
- A. The AP is configured to use channel 36
- B. Their laptops are SISO clients
- C. The AP is on channel 144
- D. The customer laptop does not support Transmit Beamforming
Answer: C
NEW QUESTION # 87
For what types of systems should you request read-only access to in order to perform an analysis of the customer's existing infrastructure?(Choose all that apply.) Response:
- A. Clients
- B. Routers
- C. Active Directory
- D. Switches
- E. RADIUS
Answer: B,D
NEW QUESTION # 88
When designing a WLAN to support voice in a large office, which design element is of the highest concern for performance?
- A. Frequency Selection
- B. Roaming
- C. AP vendor
- D. Band steering
Answer: B
NEW QUESTION # 89
In addition to a copy of your design, which tools should you use to ensure the installation team deploys APs where you have them designed to be located?
- A. Ladder and a pen
- B. RF spectrum analyzer and packet capturing software
- C. GPS and a map
- D. Camera and marking tools
Answer: D
NEW QUESTION # 90
Prior to meeting with the customer for the first time, you should do which of the following?
Response:
- A. Research the customer as much as possible. Try to understand what their business is, who their customers are, and any other information you can find regarding product lines and recent press announcements.
- B. Plan an initial design to present to them.
- C. Find out what vendor their competitors use.
- D. Decide which vendor they will benefit most from.
Answer: A
NEW QUESTION # 91
During a validation site survey, you realize that the installers mounted some of the APs above the ceiling.
They said that this was a request from
the building architect due to aesthetics constraints. During the requirements gathering, you weren't advised about any aesthetics constraints from the main stakeholder of the project. What should you do in this case?
- A. Remove all external antennas and use only the internal antennas to reduce multipath.
- B. Leave it as it is and allow automatic channel management to correct any issues.
- C. Increase the output power on all APs by 6 dB immediately.
- D. Advise the stakeholder that WLAN performance requirements will not be met and a new design process will be needed to meet the requirements.
Answer: D
NEW QUESTION # 92
What differences exist between VLANs in wireless and wired domains?
Response:
- A. Wireless VLANs are never carried in 802.11 frames that cross the wireless medium. VLAN identifiers are always carried in Ethernet frames to indicate the proper VLAN.
- B. Wireless VLANs are not effective for segmenting the available services and network permissions available to clients. Wired VLANs are effective for this purpose.
- C. Wireless VLANs do not always segment traffic into separate broadcast domains on the wireless medium. Wired VLANs do segment broadcast domains on the wired network.
- D. Wireless VLANs are ineffective for utilizing a single set of infrastructure equipment to provide different services to different client groups. Wired VLANs are effective for this purpose.
Answer: C
NEW QUESTION # 93
What is the most suitable antenna option to be used when designing a WLAN infrastructure with APs mounted on a ceiling with a height of more than 20 feet and having all of the client stations used from the floor?
- A. Low-gain dipole
- B. Patch
- C. Grid
- D. Dish
Answer: B
NEW QUESTION # 94
......
Free CWDP-304 Test Questions Real Practice Test Questions: https://www.realexamfree.com/CWDP-304-real-exam-dumps.html
View CWDP-304 Exam Question Dumps With Latest Demo: https://drive.google.com/open?id=1Qm5A3U_obmEyCNRkOub5jOP6-qKfbsGW
