H35-560 Dumps Updated Jan 18, 2022 Practice Test and 83 unique questions
2022 Latest 100% Exam Passing Ratio - H35-560 Dumps PDF
NEW QUESTION 25
Which of the following results can be reported in the Measurement Report? (Multiple choice)
- A. SINR
- B. RSSI
- C. RSRQ
- D. RSRP
Answer: C,D
NEW QUESTION 26
What are the wireless indicators that need to be paid attention to during the drive test? (multiple choices)
- A. BLER&rate
- B. Up and Downmcs
- C. RSRP&RSRQ&RSSI&SINR
- D. Ec/Io
Answer: A,B,C
NEW QUESTION 27
Which of the following descriptions are correct for cross-zone coverage? (Multiple choice)
- A. Cross-area coverage may cause UE transmit power limitation, causing access failure
- B. For LTE, cross-area coverage will not cause interference to its neighboring cells
- C. Cross-area coverage may result in unbalanced load between the cross-covered base station and surrounding base stations, resulting in low resource utilization of surrounding base stations
- D. Over-area coverage may form "islands", leading to dropped calls
Answer: A,C,D
NEW QUESTION 28
Which of the following factors does not need to be considered when dividing a Cluster?
- A. Traffic
- B. Test route
- C. weather
- D. terrain
Answer: C
NEW QUESTION 29
Regarding TA planning, which of the following statements is incorrect?
- A. The TA plan of LTE should be consistent with the LA plan of 2G/3
- B. The number of cells in the TA of LTE should be smaller than the number of cells in the corresponding LA of 2G/3G
- C. Each single carrier cell can belong to multiple Tas
- D. Currently TAL of LTE can contain up to 16 TAs
Answer: B
NEW QUESTION 30
Which of the following factors affect the theoretical peak of LTE cells? (multiple choice)
- A. Modulation(MCS)
- B. MIMOmodel
- C. Communitybandwidth
- D. UEability
Answer: A,B,C
NEW QUESTION 31
ASSTTANT is a front-end test tool independently developed by Huawei, which can display test data, replay test data, and export test data.
- A. True
- B. False
Answer: B
NEW QUESTION 32
The SINR of each codeword can be obtained through the Probe drive test tool, and the higher the SINR, the better.
- A. True
- B. False
Answer: A
NEW QUESTION 33
Single-site verification refers to the self-inspection and verification of the equipment functions and coverage capabilities of a single-site after the eNB hardware installation and debugging are completed.
- A. True
- B. False
Answer: A
NEW QUESTION 34
The LTE system can only switch based on frequency priority.
- A. True
- B. False
Answer: B
NEW QUESTION 35
The drive test scenario judges the success of the handover, usually based on the signaling. On the terminal side, which of the following signaling starts the handover process?
- A. Measurement Report
- B. Handover Request
- C. Handover Command
- D. Measurement Control
Answer: A
NEW QUESTION 36
If the cell radius is 90 kilometers, which of the following should be used for the PRACH preamble format?
- A. Format 2
- B. Format 3
- C. Format 1
- D. Format 4
Answer: B
NEW QUESTION 37
For a dual-channel room with single polarization scenario, when antennas are deployed in a long and narrow corridor, in order to reduce antenna correlation, what is the relationship between the antenna spacing and the wavelength of the current frequency band?
- A. skyLine spacing is greater than4Waveslong
- B. skyLine spacing is greater than2Times wavelong
- C. skyLine spacing is less than4Waveslong
- D. skyLine spacing is greater than10Waveslong
Answer: A
NEW QUESTION 38
There are 503 PCI physical cell identifiers.
- A. True
- B. False
Answer: B
NEW QUESTION 39
The LTE system requires an uplink synchronization system. Uplink synchronization is mainly to eliminate interference between different users in a cell.
- A. True
- B. False
Answer: A
NEW QUESTION 40
The current frequency spectrum of China Mobile's F-band is 1880MHz to 1900MHz.
- A. True
- B. False
Answer: A
NEW QUESTION 41
In the case of FTP download or upload (or packet filling) without manual intervention, the throughput rate should be maintained at this time. If there is a sudden drop, call drops may occur.
- A. True
- B. False
Answer: A
NEW QUESTION 42
Before coverage analysis, it is necessary to obtain basic data such as the planning plan, site distribution, base station configuration, antenna feeder configuration, RS power and service load characteristics of the optimized target are a. Then obtain the information of the existing network data, conduct a comparative analysis, and find out the areas where the coverage problem may exist.
- A. True
- B. False
Answer: A
NEW QUESTION 43
For the following LTE neighborhood planning, which description is correct? (Multiple choice)
- A. ANR function can completely replace the neighboring area planning of the initial network
- B. Because there is no sequence problem in the neighboring area of LTE, and the detection period is very short, it is only necessary to consider not missing the neighboring cells without needing to sort the neighboring cells strictly according to the signal strength.
- C. The directly adjacent cell geographically is generally used as a neighboring area.
For dense urban areas and ordinary urban areas, due to the relatively short distance between stations (0.3~1.0 km), neighboring areas should do more
Answer: A,B,C
NEW QUESTION 44
Which of the following statements about LTE tools is correct? (Multiple Choice)
- A. OMStar can be used for network verification
- B. M2000 can be used to configure the network and check the message system.
- C. Probe can be used for road test and playback
- D. PRS can be used for simulation and base station selection
Answer: A,B,C
NEW QUESTION 45
In the downlink scheduling, which factors will affect the allocation of downlink shared resources and the selection of MCS? (Multiple Choice)
- A. Cache status
- B. The wireless environment where the user is located
- C. UE capability level
- D. PHR (power headroom report) of UE
Answer: B,C
NEW QUESTION 46
......
Verified H35-560 dumps Q&As - 100% Pass from RealExamFree: https://www.realexamfree.com/H35-560-real-exam-dumps.html
