Get 2021 Updated Free F5 301a Exam Questions & Answer
301a Dumps PDF and Test Engine Exam Questions
Certification Path of F5 301a: BIG-IP LTM Specialist: Architect Set-Up & Deploy Exam
The second test is F5 301a. Candidates who complete the course successfully will be F5 Certified! BIG IP status, Administrator. This test would assist the student in comprehending how a packet is handled after it arrives at the computer (connection table, packet filters, etc.). Learn how a virtual server responds to an order. Isolate where the problem may be based on the processing order if you have a complex connection question. Determine a virtual server’s current condition. Check to see whether a virtual server is listening on the correct port. Check to see whether a virtual machine is installed with the correct IP address. Check to see whether the virtual server is set up with the right profiles.
Specialist, F5 BIG-IP Local Traffic Manager (LTM): Maintain & Troubleshoot The F5 Certified Technology Specialists Certification is linked to the 301a Exam. This 301a Exam verifies the abilities to plan, execute, manage, and troubleshoot advanced F5 product functionality in order to improve the effectiveness of an Application Delivery Network. This 301a exam also assesses candidates' abilities to apply their knowledge of underlying concepts, such as SSL-based VPN deployment and symmetric or asymmetric acceleration, to incorporate Local Traffic Manager into current networks as well as new implementations. The terms “network administrator” and “network engineer” are interchangeable. Typically, you should expect the same work positions after completing this degree whether you retain or seek it.
How to Prepare For F5 301a: BIG-IP LTM Specialist: Architect Set-Up & Deploy Exam
Preparation Guide for F5 301a: BIG-IP LTM Specialist: Architect Set-Up & Deploy Exam
Introduction
An F5 Certified BIG-IP Administrator can handle application delivery networks (ADNs) and F5 Traffic Management Operating System (TMOS) devices, as well as conduct routine management and troubleshooting. The F5-CA qualification requires passing two exams:
- Exam 101-Fundamentals of Application Delivery
- Exam 301a-TMOS Administration
Pre-existing BIG-IP implementations and provisional fault isolation are managed by an F5 Certified BIG-IP Administrator. They must be able to edit BIG-IP artefacts and make appropriate configuration adjustments. They’re still in charge of application delivery networks (ADNs) and managing and troubleshooting F5 Traffic Management Operating System (TMOS) devices on a regular basis. These Certified Experts manage BIG-IP infrastructure such as virtual servers, pools, pool owners, nodes, accounts, and displays using TMSH and a setup utility. They also maintain BIG-IP repositories and build, rebuild, and manage them. Certified BIG-IP Administrators must therefore review the state, functionality, and statistics of a resource in order to consider how BIG-IP networks are actually handling traffic.
The function of BIG-IP systems as a proxy mechanism inside an ADN is defined by administrators. BIG-IP devices are set up, licensed, and provisioned by them. Profiles are used by a Certified BIG-IP Administrator to monitor how BIG-IP networks handle traffic across virtual servers. They’re also in need of utilizing different medical methods to troubleshoot and diagnose issues. After it has been mounted, configured, and applied, passing this exam demonstrates independence in conducting day-to-day operations and simple troubleshooting of TMOS-based systems in different application environments. Individuals may opt to finish their credential path here or go on to the Technical Professional, Technical Specialist, Cloud, or Security Solutions tracks. In this guide we will cover all the aspects of F5-301a dumps and F5-301a practice exams.
NEW QUESTION 60
An LTM Specialist plans to enable connection mirroring for a virtual server in an HA environment.
What must the LTM Specialist consider before implementing the configuration change?
- A. Decreased number of possible concurrent connections to that virtual server
- B. The add-on license that is required for this feature to be available
- C. Impact on system performance that might be noticeable
- D. Creating the required separate interface for connection mirroring
Answer: C
Explanation:
Connection mirroring will bring performance consumption
NEW QUESTION 61
A virtual server configuration for traffic destined to a server is as shown:
HTTP traffic is destined to the 10 10.20.1 server from the source
Based on precedence, which virtual server accepts this traffic?
- A. MyVS4
- B. MyVS3
- C. MyvS1
- D. MyVS2
Answer: D
NEW QUESTION 62
An LTM Specialist is configuring a virtual server with an IP address.
Which configuration is unsupported?
- A. Standard virtual server with an HTTP profile
- B. Performance 14 virtual server with an HTTP profile
- C. Standard virtual server with a TCP profile
- D. Performance 14 virtual server with a FastHTTP profile
Answer: B
NEW QUESTION 63
An LTM Specialist has detected that a brute force login attack is occurring against the SSH service via a BIG-IP management interface. Login attempts are occurring from many IPs within the internal company network. BIG-IP SSH access restrictions are in place as follows:
The LTM Specialist has determined that SSH access should only occur from the 192.168.1.0/24 and 172.16.254.0/23 networks.
Which tmsh command should the LTM Specialist use to permit access from the desired networks only?
- A. modify/sys allow replace-all-with {''192.168.1.00/24'', ''192.16.254.0/23''}
- B. modify/sys sshd login enable {''192.166.10/24'''' ''172.16 254 0/23
- C. modify.sys sshd allow add {''192.168. 10/24 , '' ''172. 16 2540/23'')
- D. modify /sys sshd login disable (''10.0.00/8'', ''172 16.0 0/12'', ''192. 168.0.0/16'')
Answer: A
Explanation:
Select C to overwrite the existing network's allow configuration over the specified network segment.
NEW QUESTION 64
Remote office users are having performance issues with a virtual hosted on the F5 LTM. The LTM Specialist reviews the configuration for the virtual server and determine that some settings are set with default profiles.
Which profile should the LTM Specialist enable to improve virtual server performance?
- A. A Stream profile for the remote user networks
- B. A FastL4 profile on the virtual server
- C. An HTTP profile for the virtual server
- D. A WAN optimized client side profile
Answer: D
Explanation:
They key word is that there are performance problem with Remote office users, no F5. The user experience can be improved through tcp optimization. The expression should be wom-tcp-wan-optimized in Protocol Profile (Client)
NEW QUESTION 65
A design requires the LTM device to become HA standby when the one of the two physical interface on the External trunk is down the External trunk is an interface on the External VLAN Which TMOS command enables this behavior?
- A. tmsh create sys ha-group External trunks add Externally
- B. tmsh create sys ha-group External trunks add External threshold 2 weight 101)
- C. tmsh modify net van External failsafe enabled
- D. tmsh create sys ha-group External trunks add ( External( attribute percent up-members 100))
Answer: B
NEW QUESTION 66
An organization's development team creates an application to put behind the F5 LTM device. The application can be quite load intensive at first, and then evens out over time. The team's load balancing method needs to select a pool after taking into account the pool member's response over the time to avoid landing on a busy pool member.
Which of the following load balancing methods meets this requirement?
- A. Fastest (application)
- B. Dynamic (node)
- C. Observed (member)
- D. Predictive (member)
Answer: D
NEW QUESTION 67
An LTM Specialist needs to use a set of addresses to access an Internet website in an outbound configuration.
Which feature should the LTM Specialist configure?
- A. SNAT address
- B. NAT address
- C. NAT pool
- D. SNAT pool
Answer: D
NEW QUESTION 68
When importing a PEM formatted SSL certificate, which text needs to appear first in the file?
- A. --START CERTIFICATE....
- B. ...SSL CERTIFICATE....
- C. ...BEGIN CERTIFICATE....
- D. ...SECURITY CERTIFICATE....
Answer: C
NEW QUESTION 69
Exhibit.
An LTM Specialist needs to configure VS^HTTP and VS_DB for an online shopping site. The VS HTTP passes the client requests to the webservers. The webservers query the database servers through the VS_DB. Initially, the LTM Specialist finds the database servers directly return the packets to the webservers.
which setting must be enabled for the configuration to function correctly?
- A. VS_HTTP snat auto map
- B. VS_DB snat auto map
- C. VS DB auto last hop
- D. VS.HTTP auto last hop
Answer: C
NEW QUESTION 70
The picture belongs to static content, you can configure static content cache in FS to meet this demand An LTM Specialist must configure session persistence for a highly available, highly utilized web-based application.
* The following requirements are provided:
* http proxy setup for security
persistence information available to the HA peer in case of failover
The LTM Specialist needs to minimize additional burden on the LTM device to the greatest extent possible.
Which persistence profile should be used?
- A. Cookie insert
- B. Destination Address Affinity
- C. Universal
- D. Source Address Affinity
Answer: A
NEW QUESTION 71
An TLM Specialist needs to configure a virtual server to terminate SSL connection on the LTM device.
Cryptographic information must be re-authorized for SSL sessions that remain open for longer than 30 seconds.
Which settings should the LTM Specialist configure in the client SSL profile?
- A. set the Handshake Timeout to 30 seconds
- B. set the Renegotiate Max Record Delay to 30
- C. set the Renegotiate Period to 30 seconds
- D. enable Require Peer SN1 Support
Answer: C
NEW QUESTION 72
An LTM device configuration is as shown:
An LTM device configuration is as shown
What should be the two expected outcomes based on this configuration? (Choose two.)
- A. A client session that has been idle for 14 minutes will be balanced to a new pool member
- B. A client session that has been idle for 20 minutes will be balanced to a new pool member
- C. A client session that has been idle for 16 minutes will be sent to the same pool member
- D. A client session that has been idle for 12 minutes will be sent to the same pool member
- E. A client session that has been idle for 48 minutes will be sent to the same pool members
Answer: B,D
NEW QUESTION 73
An LTM Specialist needs to provide access to a 8BG-IP to device for a company's support person access to the BIG IP device, but are NOT allowed to change any settings All support the support remote access to the BIG-IP device, but are NOT allowed to change ant settings. All support have accounts in the company's Active Directory Which method is appropriate to provide access for the support personnel to the BIG-JP device?
- A. configure remote authentication for all users with a default user role of Guest
- B. configure remote authentication for all users with a default user role of Operator
- C. configure remote authentication and map support personnel users to the Operator user role
- D. configure remote authentication and map support personnel users to the Guest user role
Answer: D
NEW QUESTION 74
An LTM Specialist needs to enable TCP connection re-use for a non-HTTP application. The application uses a simple request response protocol where each request and response is contained within a single packet.
Which configuration option should the LTM Specialist adjust?
- A. use a Performance (Layer 4) Virtual Server
- B. assign a OneConnect profile
- C. increase the connection limit for pool members
- D. increase the idle Timeout in a custom TCP profile
Answer: B
NEW QUESTION 75
An HA pair of LTM devices that load balance multiple HTTPS applications utilizes highly customized RAM Cache and compression profiles on each virtual server. The LTM Specialist who is administering the HA pair regularly observes entines in the log similar to the following:
tmm tmm I708S1 011e0002.4. sweeper_update: aggressive mode activated (117504/138240 pages) No DoS attacks arc occurring. No user problems have been reported. Which step should the LTM Specialist take to help mitigate the issue?
- A. change the Adaptive Reaping Low watermark
- B. allocate less memory to the RAM cache feature
- C. use a OneConnect profile
- D. change the Adaptive Reaping High watermark
Answer: A
NEW QUESTION 76
An LTM Specialist creates an Analytics wide to show the type of browsers used to access a certain application. However, the generated statistics only sum up all transaction for that application under one item called ' Aggregated.'' What should the LTM Specialist do to resolve this problem?
- A. Drill down into the stats to show the User Agents correlated in the Aggregated group.
- B. Verify that the Analytics profile is assigned to the applications virtual server.
- C. Make sure ''User Agent'' is selected in the Analytics profile.
- D. Make sure ''User Sessions'' is selected in the Analytics profile
Answer: C
NEW QUESTION 77
What should the LT'M Specialist add to the virtual server?
- A. two Stream profiles and an iRule with the command of STREAM expression (@http:// @https:// @@internalapp@publicapp@)
- B. one Stream profile and an iRule with the command of STREAM expression (@http:// @https:// @@internalapp@publicapp@)
- C. one Stream profile with the expression of @http:// @https:// @
- D. Two Stream profiles, one profile for each rewrite requirement
Answer: B
NEW QUESTION 78
......
Verified 301a exam dumps Q&As with Correct 150 Questions and Answers: https://www.realexamfree.com/301a-real-exam-dumps.html
Get New 301a Certification – Valid Exam Dumps Questions: https://drive.google.com/open?id=19vppy4JLYSfgz8jqf6fgc_K9C8pcb5yy
